Product | Communication | RF | 433Mhz RF Link Kits - With Encoder and Decoder
433Mhz RF Link Kits - With Encoder and Decoder
433Mhz RF Link Kits - With Encoder and Decoder
41668
More than 100
 
US$12.80 Loading ...
 
Share/Save/Bookmark


433Mhz RF Link Kits - With Encoder and Decoder



1、Transmitter module :



Special Parameter :

Frequency : 433Mhz

Modulation : ASK

Working Voltage : 4~9V DC

Frequency difference:min±75KHz max±150KHz

Launching power: 50mW (9V)

Working current:<10mA (9V)

Frequency stability : 0.037ppm/℃

Temperature range:-20℃--+85℃

Transmission rate : ≤10Kbps

Encoder : PT2262 or Compatible Chip

Timing resistor:1.5M

Receiver Sensibility: -105dbm

Emission Distance: 500m in open ground

Size : 37 x 23 x 8mm

This module have been pinout All data interface, convenient for useage, and only when more than one data bits among 10 ~ 13 four data bits are high electricity level, the module will transmit the high frequency signal .

2、Receiver module :

This is superregeneration Decoder Receiver

Decoder : PT2272

Size: 41x24x6 mm

It can be compatible with transmitter with 2262 chip ,433MHZ ,and 1.5M Timing resistor

Specialized superheterodyne receiving module has an inherent disadvantages :

when remote control signal is too strong and the module oscillation signal will be blocked, and unable to properly receive signal.
So at this time, you should be away for some distance (such as 10 meters) and then it can work normally.
 

In order to test whether the receiving modules work normally, give a 5 v dc voltag between the VCC and GND interface of receiving module, and connect light emitting diode with pin 10, 11, 12, 13, 17 interface respectively

When we press A button of trasmitter module, its corresponding pin 11 road LED will be light, until press the other button such as B key, pin 11 extinguish and pin 12 will be light.

Pin 17 interface is the effective decoding output port, no matter which button of the transmitter we push, it will become high level as long as decoding successfully, the transmitter stop transmitting immediately and it will extinguish

Warning: this kit is not suitable for data transfer but remote control. Safe for 2 commands/secon

3、Encoding and Decoding :


The popular link is like this: MCU -> Encoder -> Transmitter ------ Receiver -> Decoder -> MCU

PT2262(Encoder) and PT2272(Decoder) are optional, their existence is to 1)avoid confusing when multiple RF links in range 2) isolate disturbance. You can integrate the encoding and decoding work to the MCUs on both side. Whenever there is no 315Mhz devices around, you may use it as direct cable connection.



Write a review
*Review title
Please enter subject.
*Your review
Please enter review.
*Rating
(Click star icon to comment)
 
Display name
*Enter security code

CAPTCHA

Please enter code
Loading ...
Best Sellers