4-Channel Relay Shield, Support XBee

Key Specifications :

Cautions :

Please be very careful while operating high voltage circuits! You may get hurt (dead!) or hurt any connected equipment if you don't know what you're doing or if you make a mistake.

Schematic :




4 groups of channels for High voltage connection

COM1                                                     Common pin

 NC1                                   Normally Closed - NC1 is connected with COM1
                                          when control port D0 is set low and disconnected when D0 is high

 NO1                                   Normally Open - NO1 is disconnected from COM1
                                          when control port D0 is set low and connected when D0 is high

Groups 2-4 are similar to Group 1, except for the control ports being D1-D3.

9v power supply connection

The function of the Terminal and the Jack is the same since they are internally connected, and you can choose either of them in needs.

IO controlling 4 on-board relays

D0-D3 4pins could be connected directly with Arduino pin number of 7-4, so that four relays could be easily controlled by the Arduino.

315M RF control interface

Together with pin of GND and 5v, they are the interface for 315M RFmodule to control the 4 relays remotely.

RFBee directly control interface

The 4 relays could be directly controlled by the RFBee through the 4 DIO ports of RFBee.

RFBee cascading control interface

As the RFBee has 12 DIO ports, 2more Relay Shield (8 more relays) could be controlled through one RFBee. HUB1 and HUB2 are the drawn-out ports of RFBee (4 as a group), which is connected to 315M RF interface of the cascading Relay Shield.

Usage :

1、With Arduino

Relay Shield could be directly controlled by Arduino.
Step1. Plug Relay Shield onto Arduino Duemilanove (or compatible) board;
Step2. Supply 9v DC power to Arduino;
Step3. Download the example code and run in Arduino IDE.

2、With 315M RF Module

Step1. Plug the Receiver onto the Relay Shield.
Step2: Supply the Relay Shield with 9v DC power.
Step3: Control the Transmitter.





Click to download the schematic diagram

下载pdf文档资料.pdf