Product | Microcontrollers | ArduPilot Mega ATMega2560 V1
ArduPilot Mega ATMega2560 V1
ArduPilot Mega ATMega2560 V1
42222
More than 100
 
US$39.98 Loading ...
 
Share/Save/Bookmark


ArduPilot Mega ATMega2560 V1 -Arduino Compatible



Description :


ArduPilot is a fully programmable autopilot that requires a GPS module and IMU sensors to create a functioning Unmanned Aerial Vehicle (UAV). The autopilot handles both stabilization and navigation, eliminating the need for a separate stabilization system. It also supports a "fly-by-wire" mode that can stabilize an aircraft when flying manually under RC control, making it easier and safer to fly. The hardware and software are all open source. The board comes with all the surface-mount parts already soldered, but requires the user to solder on connectors. Firmware is already loaded, but the autopilot software must be downloaded and loaded onto the board by the user. It can be programmed with the Arduino IDE.

APM can be used for either airplanes or rotary wing aircraft, including quadcopters and other multicopters and traditional helicopters. The autopilot hardware is the same, and you can load whichever firmware is appropriate for the aircraft you've got via the free Mission Planner. (You may choose to add other sensors to improve performance for specific airframes, such as an airspeed sensor for airplanes or a magnetometer for mulitcopters). All details and instructions can be found at each project's Home Page.

 


Features :


1、Designed to be used with autonomous aircraft, quadcopters and helis.

2、Based on a 16MHz Atmega2560 processor.

3、 Built-in hardware failsafe that uses a separate circuit (multiplexer chip and ATMega328 processor) to transfer control from the RC system to the autopilot and back again.

4、Includes ability to reboot the main processor in mid-flight.

5、Dual-processor design with 32 MIPS of onboard power.

6、 Supports 3D waypoints and mission commands (limited only by memory--approximately 600-700 waypoints with current code, but can be adapted for more).

7、128k Flash Program Memory, 8K SRAM, 4K EEPROM.

8、Comes with a 6-pin GPS connector (EM406 style).

9、Has 16 spare analog inputs (with ADC on each) and 40 digital input/outputs to add additional sensors.

10、Four dedicated serial ports for two-way telemetry (using optional XBee modules) and expansion.

11、Can be powered by either the RC receiver or a separate battery.

12、Hardware-driven servo control, which means less processor overhead, tighter response and no jitters.

13、Eight RC channels (including the autopilot on/off channel) can be processed by the autopilot.

14、LEDs for power, failsafe status, autopilot status .

15、Dimensions: 40mm x 69mm.

This item can be used with ArduPilot Mega IMU Shield V1 together as below :

 

 

Click to see the detail information about ArduPilot Mega Kit

 


Click to visit ArduPilot Project Homepage

Write a review
*Review title
Please enter subject.
*Your review
Please enter review.
*Rating
(Click star icon to comment)
 
Display name
*Enter security code

CAPTCHA

Please enter code
Loading ...

Best Sellers