10Hz MediaTek MT3329 GPS Module With Antenna
General Description :
The state-of-the-art 66 channels MediaTek MT3329 GPS Engine.
High sensitivity: Up to -165dBm tracking, superior urban performance.
USB/ UART/ RS232 Interface.
Build-in patch antenna for optimal sensitivity.
DGPS(WAAS, EGNOS, MSAS) support (optional by firmware).
Maximum update rate : up to 10Hz (optional by firmware).
Note that the new MediaTek has custom and exclusive firmware that allows the unit to output an efficient and very compressed binary protocol (This firmware will only work with this kinds of modules!). You can still change between NMEA and Binary protocol with standard MTK messages, and switch the refresh rate between 1hz to 10hz, or set any standard serial baud rate (by default is set to 38400 bps and custom binary protocol).
Arduino example for decoding the custom binary protocol is provided. Remember to install the library folder "GPS_MTK" inside the Arduino IDE "libraries" folder "arduino-00XXlibraries". For the most updated code, please go to this page.
Once there, download the most recent "ArduPlane X.XX.zip" file; open the "libraries" folder and then "AP_GPS" where you'll find the most recent code.
1、Support fast TTFF function.
2、Based on MediaTek Single Chip Architecture.
3、Dimension：16mm x 16mm x 6mm.
4、L1 Frequency, C/A code, 66 channels.
5、High Sensitivity：Up to -165dBm tracking, superior urban performances.
6、Position Accuracy：< 3m CEP (50%) without SA (horizontal).
7、Cold Start is under 35 seconds (Typical).
8、Warm Start is under 34 seconds (Typical).
9、Hot Start is under 1 second (Typical).
10、Low Power Consumption：48mA @ acquisition, 37mA @ tracking.
11、Low shut-down current consumption：15uA, typical.
12、DGPS(WAAS, EGNOS, MSAS) support (optional by firmware).
13、Support USB/ UART/ RS232 Interface.
14、Support AGPS function (Offline mode : EPO valid up to 14 days).
15、Includes a molex cable adapter, 5 cm!! (EM-406/uBlox Adapter cable).
16、Includes the new basic adapter!! (Mediatek Adapter Basic).
17、Weight: 8 g.
This GPS module can be used with ArduPilot Mega V2.0 Fully Assembled Kit .
If with GPS, please click to see : ArduPilot Mega V2.0 Fully Assembled Kit With GPS
Click to see the detail information about ArduPilot Mega V1.0 Fully Assembled Kit
Click to see the detail information about ArduPilot Mega ATMega2560 V1
Click to see the detail information about ArduPilot Mega IMU Shield V1
Click to see the detail information about ArduIMU+ V3 Module
Join our newsletter today, to get latest product information and promotion code.Loading ...